Model Tech P-47 Thunderbolt Spezifikationen PDF herunterladen (Seite 51)

See other exciting Modeltech ARF airplanes at http://modeltech.globalhobby.com

❑ Kwik Bond 5 Minute Epoxy

❑ # 1 Phillips Head Screwdriver

❑ Excel Modeling Knife

❑ Electric Drill

❑ 1/16", 5/64" & 5/16" Drill Bits

❑ Ernst Airplane Stand

❑ Ruler

❑ Pencil

YOU'LL NEED THE FOLLOWING PARTS:

SECTION 23: COWLING INSTALLATION

YOU'LL NEED THE FOLLOWING SUPPLIES:

❑ Dremel Tool w/Sanding Drum & Cutting Disc

❑ 220 Grit Sandpaper w/Sanding Block

❑ Masking Tape

❑ Paper Towels

❑ Rubbing Alcohol

❑ Epoxy Mixing Sticks

❑ Epoxy Mixing Cups

❑ (1) Molded Fiberglass Cowling

❑ (4) Hardwood Cowl Mounting Blocks (D25)

❑ (4) 3mm x 12mm Wood Screws

❑ (4) 3mm Flat Washers

Step 1: Installing the Cowl Mounting Blocks

❑ Align and glue the cowl mounting blocks to the firewall

using a generous amount of 5 minute epoxy. Hold the blocks

in place using masking tape until the epoxy fully cures.

☞

The blocks are glued to the 12 o'clock, 3 o'clock, 6 o'clock

and 9 o'clock positions on the firewall.

Step 2: Aligning the Cowling

❑ Remove the needle valve and muffler assembly from your engine and set them aside for now.

❑ Using a Dremel tool with a sanding drum, carefully

remove the molded flange from the inner radius of the

cowling.

☞

Work slowly, removing a small amount of material at a

time, so you don't damage the cowling.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 67 68

Keine Kommentare

Model Tech P-47 Thunderbolt Spezifikationen Seite 51