Model Tech P-47 Thunderbolt Spezifikationen PDF herunterladen (Seite 24)

Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net

Step 2: Installing the Nylon Landing Gear Straps

❑ Each main gear wire is held in place using two flat nylon

landing gear straps and four 3mm x 12mm wood screws.

Working with one gear wire for now, position two straps equal

distances from each end of the wire.

❑ Install the landing gear straps using four 3mm x 12mm

wood screws. Tighten the screws completely to secure the

landing gear wire into place.

❑ Repeat the previous procedures to install the landing gear straps on the second landing gear wire.

Step 3: Installing the Landing Gear Covers

❑ Using a modeling knife, remove the covering material

from over the four 3mm diameter predrilled holes in each

landing gear cover.

❑ While holding the straps in place, use a pencil to mark the locations of the mounting screws on the landing gear block.

❑ Remove the nylon straps and drill four 5/64" pilot holes into the landing gear block.

☞

Be careful not to drill through the top of the wing.

IMPORTANT

Before installing the landing gear covers in the next procedure, make sure the curved edge of the gear covers are toward

the leading edge of the wing.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 67 68

Keine Kommentare

Model Tech P-47 Thunderbolt Spezifikationen Seite 24