Model Tech P-47 Thunderbolt Spezifikationen PDF herunterladen (Seite 37)

See other exciting Modeltech ARF airplanes at http://modeltech.globalhobby.com

❑ # 1 Phillips Head Screwdriver

❑ Promax Canopy Scissors

❑ Ernst Airplane Stand

YOU'LL NEED THE FOLLOWING PARTS:

SECTION 19: FUEL TANK ASSEMBLY & INSTALLATION

YOU'LL NEED THE FOLLOWING SUPPLIES:

❑ Ruler

❑ 220 Grit Sandpaper w/Sanding Block

❑ (1) 360cc Fuel Tank

❑ (1) 20mm Diameter Aluminum Front-Plate

❑ (1) 18mm Diameter Aluminum Back-Plate

❑ (1) Rubber Stopper

❑ (1) Silicon Fuel Tubing

❑ (1) Weighted Fuel Pick-Up

❑ (2) Aluminum Tubes

❑ (1) 3mm x 20mm Machine Screw

Step 1: Assembling the Rubber Stopper

❑ Using 220 grit sandpaper, carefully smooth each end of the two aluminum tubes. This will prevent the fuel tubing

from being accidentally cut when it is installed later.

❑ Push the two tubes into the rubber stopper (from behind)

until the tubes stick out 3/8" in front of the stopper.

WARNING

Do not open the third hole in the stopper. It will not be used.

❑ Slide the 18mm back-plate over the ends of the tubes

and push it against the back of the stopper.

❑ Carefully bend the longer of the two aluminum tubes up

at a 45º angle.

☞

Be careful that you don't kink the tube when making the

bend.

To make bending the tubing in the next procedure easier, using a specialized tubing bender would be a good idea. The

Magnum 1/8" Tubing Bender (P/N 237474) would be a good choice.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 67 68

Keine Kommentare

Model Tech P-47 Thunderbolt Spezifikationen Seite 37