Model Tech P-47 Thunderbolt Spezifikationen PDF herunterladen (Seite 40)

Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net

Step 1: Installing the Elevator Control Horns

❑ Using a ruler and a pencil, measure out 3/4" from the inside edge of each elevator half, at the hinge line, and draw

a mark.

IMPORTANT

Do not measure out from the side of the fuselage. Measure from the inside edge of the elevator half.

❑ Position one nylon control horn onto the bottom of the elevator half, aligning the centerline of the control horn with

the mark you drew. The control horn should be perpendicular to the hinge line and the clevis attachment holes in the

control horn should be directly over the hinge line.

❑ Kwik Bond Thin C/A

❑ # 1 Phillips Head Screwdriver

❑ Adjustable Wrench

❑ Wire Cutters

❑ Needle Nose Pliers

❑ Excel Modeling Knife

YOU'LL NEED THE FOLLOWING PARTS:

SECTION 20: ELEVATOR CONTROL SYSTEM INSTALLATION

YOU'LL NEED THE FOLLOWING SUPPLIES:

❑ Electric Drill

❑ 5/64" Drill Bit

❑ Ernst Airplane Stand

❑ Ruler

❑ Pencil

❑ (2) 755mm Nylon Pushrod Tubes

❑ (2) 2mm x 255mm Threaded Wires

❑ (2) Nylon Control Horns w/Backplates

❑ (4) 2mm x 25mm Machine Screws

❑ (1) 2mm x 20mm Machine Screw

❑ (3) Nylon Clevises

❑ (1) Nylon Pushrod Joiner Plate

❑ (2) 2mm x 10mm Flange-Head Wood Screws

❑ (2) 2mm Flat Washers

❑ (1) 2mm Hex Nut

❑ (1) Clear Tubing

❑ Using a pencil, mark the positions for the control horn

mounting screws, then remove the control horn.

❑ Carefully drill the holes for the mounting screws using a

5/64" drill bit.

IMPORTANT

Make sure to drill the holes straight down and not at an angle.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 67 68

Keine Kommentare

Model Tech P-47 Thunderbolt Spezifikationen Seite 40