Model Tech P-47 Thunderbolt Spezifikationen PDF herunterladen (Seite 12)

Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net

Step 4: Installing the Plywood Wing Bolt Doubler

❑ Set the wing bolt doubler onto the bottom of the wing.

The rear edge of the doubler should be 3/32" in front of the

trailing edge of the wing and the centerline of the doubler

should be lined up with the centerline of the wing.

☞

The groove in the doubler (centerline) should face away

from the surface of the wing.

❑ While holding the doubler in place, use a pencil to draw an outline of the doubler onto the wing's surface.

❑ Remove the doubler from the wing.

❑ Using a modeling knife, cut away and remove the

covering material from inside the outline.

IMPORTANT

Never glue anything directly to covering material. For the

strongest bond, always remove the covering from the gluing

surfaces.

❑ Glue the doubler into place using a generous amount of thick C/A. Any excess C/A can be quickly removed using a

paper towel soaked with a small quantity of C/A debonder.

❑ Kwik Bond Thin C/A

❑ # 2 Phillips Head Screwdriver

❑ Dubro 5mm Tap & Drill Set

❑ Electric Drill

❑ 5/32" & 13/64" Drill Bits

YOU'LL NEED THE FOLLOWING PARTS:

❑ (1) Fuselage

❑ (2) 5mm x 35mm Machine Screws

SECTION 9: WING MOUNTING

❑ (2) 5mm Flat Washers

❑ (2) 5mm Blind Nuts - optional

YOU'LL NEED THE FOLLOWING SUPPLIES:

❑ Ernst Airplane Stand

❑ Ruler

❑ Pencil

❑ Masking Tape

Step 1: Aligning the Wing

❑ Set the wing on your work table so that the bottom is facing up toward you.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 67 68

Keine Kommentare

Model Tech P-47 Thunderbolt Spezifikationen Seite 12