Model Tech P-47 Thunderbolt Spezifikationen PDF herunterladen (Seite 41)

See other exciting Modeltech ARF airplanes at http://modeltech.globalhobby.com

❑ Install the nylon control horn using two 2mm x 25mm

machine screws.

☞

Don't overtighten the screws. You don't want to crush

the elevator.

❑ Repeat the previous procedures to install the second control horn on the other elevator half.

Step 2: Installing the Elevator Pushrod Tubes

❑ Install one 2mm x 20mm machine screw, two 2mm flat

washers and one 2mm hex nut into the center hole in the

nylon pushrod joiner plate. Tighten the assembly securely.

☞

One washer should be installed at the front of the plate

and one at the back (flat side).

❑ Apply a drop of thin C/A to the nut to prevent it from

loosening. Allow the C/A to dry before proceeding.

❑ Secure both 755mm long pushrod tubes to the back of

the nylon joiner plate using two 2mm x 10mm flange-head

wood screws.

☞

Be sure to tighten the screws firmly.

❑ Apply a drop of thin C/A to each pushrod tube where it

attaches to the joiner plate. The C/A will "wick" down into

the tube, locking the wood screws into place.

❑ Using a modeling knife, cut a 1/4" long piece of clear

tubing and slide it over the base of one nylon clevis.

❑ Thread the clevis onto the machine screw.

IMPORTANT

Make sure the clevis is threaded on completely, so there's no

chance of it coming loose.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 67 68

Keine Kommentare

Model Tech P-47 Thunderbolt Spezifikationen Seite 41